Search results for: 'circulation pump foam a master sp2 cs 75'
- Related search terms
- Master Spa - CLSEPRSET3 - Clarity & Healthy Living EPR Filter Set - (2) X268548 - PMA-R3 and PMA-EPR - (1) X268532
- Master Spa - X232607 - 1" Lighted Halo Air Control
- Master Spas - Topside Panel, MP900, No Overlay, For MS40 - X310203, 50305
- Master Spa - X245375 - 2 inch DSG 6-Spoke Diverter
- Master Spas, Down East, Emerald Spas Suction Drain Cover, 4-7/8 inch 0.D. VGB Law Compliant Replaced 0bsolete Original
The Air Control 1” Toggle makes it easy to open and close the air control valve on your spa or hot tub. This spa air control toggle is designed to work with Master Spas® manufactured on or after 2012, as well as Clarity Spas (2013), Contractor Series (2012), and Legacy Whirlpool (2012). Check out the Product Description for specific model numbers.
-
You can only get the same functionality and appearance out of your two-button topside pump control by Down East Spas by choosing a decal made by the original manufacturer. That is why we are proud to offer the Down East 2-Button Overlay product. This decal for your topside pump control offers the same appearance and functionality as your original Down East Spas overlay — but for a fraction at what you’d pay at your local spa or hot tub shop!
-
The 70" x 83" Hot Tub Cover (Short-edge Fold) (SKU: 457187) is designed to fit your Master Spas® hot tub. This cover ensures extreme energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.
Note: This particular cover folds along the shortest 70-inch edge. For a hot tub cover folding on the long edge, please see 83" x 70" Hot Tub Cover (Long-edge Fold).
-
The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.
-
The Bracket Kit for Master Spas CoverMate I with Master Bracket is one of the sections that makes up the CoverMate I model of a hydraulic cover lifter. This Extended Pivot Arm has SKU# 100571 and is a replacement part for the CoverMate I, which is sold here by Master Spa Parts. The Master bracket attaches to the wood in the upper-right corner to provide additional support.
-
The 30 Amp Power Input Fuse by Master Spas is a replacement power fuse made to go in your spa’s PC board. This particular fuse supplies all of the power to your spa’s pumps. Keeping this fuse in tip-top shape is one of the best ways to ensure your spa’s functionality.
-
The 108" x 94" Master Spas® replacement hot tub cover (SKU: X454994) is designed to fit your Master Spas® hot tub. This OEM factory hot tub cover comes with a 1. lb foam density, upgraded rubber grip handles and long steam stopper cushions to help prevent heat loss and make it extremely energy efficient!
Note: This cover folds along its longest dimension.
-
Thumbscrew 1/4 - 20 x 1.75 inch. These are used to secure your corner skirting pieces on your spa in place. This part is the longer of the two thumb-screws available.
