Search results for: 'monte pump frame long by six'
- Did you mean
- mount pump frame long by six
- mount pump frame long by sx
- Related search terms
- Pump and motor for a down east single pump spa
- pump for a BAJA 6100 series spa tub
- pump for pheonix spa PHX01?
- Pump seal kit for 2001 down east Exeter spa
- Pump motor for 2004 1100 down east spa
As an all-in-one spa and hot tub treatment kit, the SpaBoss Hot Tub Chemical Starter Kit has everything you need to get your spa or hot tub up and running — and ensure it is always safe and ready to use. As a six-piece hot tub treatment kit, it’s quite an economical option, too!
The Hot Tub Chemical Starter Kit (SKU: X777700) includes:
- Granular pH Plus (1.5 lbs)
- Granular pH Minus (2 lbs)
- Granular Non-Chlorine Shock (2 lbs)
- Granular Chlor-Aid (2 lbs)
- Liquid Prevent II (16 oz)
- AquaChek Test Strips (50 Strips)
-
Extend the life of your spa cover with Spa Ease Cover Conditioner!
-
Measure the chemical balance of your hot tub water with AquaChek Spa 6-in-1 Test Strips in 15 seconds.
- Count: 50 test strips
- Tests for: Total Chlorine, Total Bromine, Free Chlorine, Total Alkalinity, pH and Total Hardness.
-
The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.
-
This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**
-
MS300 AVU Control Pack with 4kW 825 Heater. This is for a 1 pump set up.
-
This Master Spa Factory OEM 78” x 78” hot tub cover replacement (SKU: X120240) is specifically designed to fit your Master Spas® hot tub. This cover is energy efficient as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal to help prevent heat loss. It is also made of a high end marine-grade vinyl covering that is mildrew treated, and consists of upgraded rubber grip handles.
-
Replacing fuses in your spa’s PC board is often a simple, straightforward solution to various problems that might arise with your spa or its features. The 20 Amp Power Input Fuse is a small piece in your spa’s PC board that allows your spa’s pumps to operate. Replacing this fuse allows you to continue to enjoy your spa and its features.
-
This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.
