Search results for: 'seri sts for part'

Keep all your essential spa controls within reach with the topside controller for 2017 Twilight Series™ models from Master Spas®. This unit features touch control operation for ease of use. This touch panel only comes with the unit itself, not the protective overlay sticker.

This topside controller comes with free shipping to the continent United States, courtesy of Master Spa Parts!

This is the replacement for X310209, X310213 S/N: 50610 and X310308.

Did you know that the amount of microbes on filtration surfaces can double every 20 minutes? The warm water and organic materials are the perfect breeding grounds for germs. But, with the Pleatco H2X® Trainer & Michael Phelps filter PMA-R4, germs and microbes don’t even have a chance. Pick up your Swim Spa ECO PUR CHARGE System Filter from the Master Spa Parts online store, today!

Enjoying remote access to your favorite television shows is easy with this simple plug and play remote eye for your flat screen TV is perfectly suited for TV systems mounted with the Master Spa Hot Tub Series.

This is a OEM factory direct replacement rubber stopper smash cap for the CoverMate I hot tub cover. Easily replace your old smash cap with this replacement!

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

The 2 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

Connect your audio system to the controller of your Master Spa hot tub using this stereo adapter. Order the stereo adapter you need for your Master Spa controller today. 

Ozone Flash Reactor

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*