Search results for: 'caldera pack sp side panel'

Legacy 1 Pump Overlay K33

1.5" Skirt Clip

This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*

TP 600 Topside W/ 15' Cord

2 x 3/4 inch 2 Barb SxSp Manifold

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!

1 Pump overlay for Clarity spas with the TP 500S Control panel

SpaBoss pH Plus easily raises pH levels in spas and hot tubs that are too low below the recommended safe range of 7.2 to 7.6. If levels are too low, your hot tub water can become acidic and other nasty side effects can happen.

2 inch 90 Degree SxS Ell

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

Wave Propulsion Control System