Search results for: 'vip spx deep side controller'

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

1.5 x 3/4 inch, 4 Barb SxS Manifold

1.5 x 3/4 inch 2 Barb SxS Manifold

The right outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your cover in the open position. While facing the open cover, the right handle is on right side.*

1 inch Pipe Extender

The CoverCatch helps keep your spa cover close by and off the ground! It is ideal for smaller sizes spas and covers.

Designed for adding a beautiful finish to your spa, the expresso oversized snap cap goes over the screws that hold your spa side panels on. This unit is a dark espresso color.

This is the replacement aluminum left bracket for your CoverMate cover lifter.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the left bracket is on the left side.*

2 inch 45 degree SxSp Street Ell

2 inch 90 Degree SxSp Street Ell

Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!

The replacement, factory direct left outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left outer handle is on the left side.*