Search results for: 'SUCTION COVER FOR XP2 SPA PUMP'

Auxiliary Pump 4 Panel (V/N 52806)

Auxiliary pump button overlay.

3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.

12 Amp, 1 Speed, 230 Volt, 56 Frame LX Pump

16.4 Amp, 2 Speed with 9 O'Clock position Wet end 

This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*

The Master Spas Freeze Plug Kit contains a plug set that works on most spa pumps. This can be loosened to drain any trapped fluid within your pump. Replacing a broken pump ? Make sure to get new freeze plugs as well.

Support arm for CoverMate I and upper support arm for the CoverMate II and CoverMate Easy.

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

Twilight, 2 Pump, 6 Button Overlay

Twilight, 1 Pump, 5 Button Overlay

This is the Extended Pivot Arm for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part is 43 inches long and is sold here at Master Spa Parts.