Search results for: 'spa coverm 7 ft x 5.5 ft'

1 x 3/8 inch Reducer Barb Adapter

1/2 x 3/8 inch Barb Adapter

3/8 x 3/8 inch Barb Coupler

1 x 3/8 inch, 4 Barb Manifold

1 x 3/8 inch, 8 Barb Manifold

The replacement, factory direct left outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left outer handle is on the left side.*

3/4 x 3/4 inch Barb Coupler

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

Thumbscrew 1/4 - 20 x 1.75 inch. These are used to secure your corner skirting pieces on your spa in place. This part is the longer of the two thumb-screws available.

The Master Spa® Factory OEM 82" x 60" replacement hot tub cover (SKU: x458260) is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6-inch thick foam insulation that tapers to 4-inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This hot tub cover (82" x 60") folds along the long edge. 

3/4 x 3/8 inch 2 Barb Manifold