Search results for: 'error covers 5 on a hot spring scale system'

Measure the chemical balance of your hot tub water with AquaChek Spa 6-in-1 Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Chlorine, Total Bromine, Free Chlorine, Total Alkalinity, pH and Total Hardness.

This is the OEM factory replacement screw kit for your CoverMate CoverShelf.

The Wrap Around Pillow from Master Spa is a larger pillow that wraps around the corner of your hot tub.

This is the five-inch nut that is a replacement part sold right here, through Master Spa Parts. This replacement piece measures five inches in diameter and works on several models within the 2005 Down East Spa series of home spas. Made of sturdy plastic this replacement part has a SKU number of X241054 and is designed to provide a tight fit in order to prevent leaks.

This is a gasket ring that is five-inches in diameter and is sold by Master Spa Parts. This replacement piece has a SKU number of X241056 and is made of quality plastic to prevent leaks. The five-inch gasket ring is easy to install on your home spa. This part ships for free throughout the continental U.S. when included in an order of $99 or more.

The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.

SpaBoss Descummer boosts the effectiveness of the filtration system in your spa or hot tub, helping to keep the water clean and free of left-over contaminants.

The powder coated aluminum coupler for the CoverMate I, CoverMate II and CoverMate III is a direct replacement for the original bar.

The 8' x 15' (94" x 180") Master Spas® swim spa replacement cover is a Master Spa Factory OEM replacement (SKU: x454158). All swim spa covers are made specifically to fit your Master Spas swim spa and come 6" thick in the middle and taper off to 4".  This cover includes an energy efficient 1.5 lb foam density and a 24 R-value, with a full length heat seal and upgraded rubber grip handles (included!). They are also available in 18 different colors!

This is a OEM factory direct replacement rubber stopper smash cap for the CoverMate I hot tub cover. Easily replace your old smash cap with this replacement!

Boomerang brackets (1 pair) are specifically designed for use with the Visionlift Boomerang Cover Lifter by Ultralift. These brackets attach to your existing Ultralift sliding bracket, allowing your hot tub cover to fully open to the ground without the need for additional drilling. 

This is the replacement right aluminum bracket or your CoverMate Cover Lifter by Leisure Concepts.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.*