Search results for: 'mini pump frame long by six'

1 1/2 inch SxSp Gate Valve

1 inch SxS Ball Valve

Measure the chemical balance of your hot tub water with AquaChek Spa 6-in-1 Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Chlorine, Total Bromine, Free Chlorine, Total Alkalinity, pH and Total Hardness.

This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**

The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.

MS300 AVU Control Pack with 4kW 825 Heater. This is for a 1 pump set up. 

This Master Spa Factory OEM 78” x 78” hot tub cover replacement (SKU: X120240)  is specifically designed to fit your Master Spas® hot tub. This cover is energy efficient as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal to help prevent heat loss. It is also made of a high end marine-grade vinyl covering that is mildrew treated, and consists of upgraded rubber grip handles.

Replacing fuses in your spa’s PC board is often a simple, straightforward solution to various problems that might arise with your spa or its features. The 20 Amp Power Input Fuse is a small piece in your spa’s PC board that allows your spa’s pumps to operate. Replacing this fuse allows you to continue to enjoy your spa and its features.

Clarity Overlay

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.

This 67" x 78" Hot Tub Cover (Short-edge Fold) hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures you energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation that tapers to 4-inches along the sides, and a full-length heat seal to prevent heat loss. Additionally, it is made of a high-quality marine-grade vinyl covering that is mildew treated and protects against UV rays. Additionally, it boasts upgraded rubber grip handles.

Note: This particular hot tub cover folds along the shorter 67" edge. 

.

This is the replacement right aluminum bracket or your CoverMate Cover Lifter by Leisure Concepts.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.*