Search results for: 'today swim sx'

Copper Heater Straps are used for connection of the Heater Unit of your spa to the Board within the Spa pack.

Easily installed.

Designed for adding a beautiful finish to your spa, the mahogany oversized snap cap goes over the screws that hold your spa side panels on. Color - mahogany.

Regular-sized snap cap to cover the screws on your hot tub or spa. Hide rusty screws and keep them out of sight. This unit is in a light teak color.

Cooper Heater Strap. This is the shorter style of the 3 we have in stock (SKU #: 300016, SKU #: 300390). Copper construction provides easily installation for connecting your spa heater to the PC Board.

This replacement product has a SKU number of X320048 and is enclosed in plastic to protect it from water that may cause corrosion. This is the Replacement Ozone product that is engineered and manufactured by Aqua Sun Ozone International. fits in a variety of models in the following models of home spas.

1/4 inch Washer for Oversized Snap Cap. These are the beauty caps that cover the screws that hold your side panels on. Available in 2 different sizes and 3 different colors.

The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.

The 4’ Cable Extension for Balboa Stereo gives you the extra reach you need to achieve the sound system setup you want for your hot tub area. Order this part (SKU#X311011) from Master Spa Parts toady.

This is an OEM factory direct replacement drain valve for your Master Spa with an on/off and hose connection.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

The 1/4-20 Threaded Insert for Wood from Master Spa Parts are threaded nuts that can be hammered or screwed into material. Used in a pre-drilled hole to provide an extra secure hold between your spa skirting parts.