Search results for: 'Return cover 5”'
- Did you mean
- return cover17 5
- return cover13 5
- Related search terms
- return a spa filter
- cover spa topside control 11499 400 1 pump system
- covers spa topside control 1999 400 1 pump system
- covers spa topside control 1996 400 1 pump system
- cover spa topside control 1996 400 1 pump system
Our Master Spas® 83" x 70" hot tub cover (SKU: 458771) is a factory direct OEM replacement cover specifically designed to fit your Master Spas® hot tub. Consisting of 1.5lb foam density, long steam stopper cushions, six-inch foam insulation, four inch tapered sides, upgraded rubber grip handles and a 24-R value (the greater the R-value, the better the heat storage and heat retention), this cover prevents heat loss and is extremely energy efficient.
Note: This hot tub cover folds along the long edge.
-
This left cover piece for the CoverMate III cover lifter snaps into the fitted location on the left side and covers all the pieces found there.
*To determine if this is the correct replacement cover pieceyou need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left cover piece is on the left side.*
-
General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.
-
The right cover piece snaps into the fitted location on the right side and covers all the pieces on that side.
*To determine if this is the correct replacement cover piece you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the right cover piece is on the right side.*
-
If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.
