Search results for: 'count spx part cc2184080'

Measure the chemical balance of your chlorine based water with AquaChek TruTest Chlorine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity

Measure the chemical balance of bromine based water with AquaChek Red 4-in-1 Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity and Total Hardness

Measure the chemical balance of your hot tub water with AquaChek Silver 7-Way Test Strips in just 15 seconds.

• Count: 100 test strips
• Tests for: Total Hardness, Total Chlorine, Total Bromine, Free Chlorine, pH, Total Alkalinity, Stabilizer (Cyanuric Acid).

Measure the chemical balance of your hot tub water with AquaChek Spa 6-in-1 Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Chlorine, Total Bromine, Free Chlorine, Total Alkalinity, pH and Total Hardness.

The Rubber Pump Mount is suitable for the elastic mounting of your replacement spa pump. These rubber mounts are simple and economical construction elements. They help to reduce the vibrations that are generated by your pump.

The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.

Make sure to buy all the parts you need for complete assembly of your replacement pump.

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

The 2 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

The 4.0kW Heater (V/N 50143) is a replacement part for selected models of the Down East Spas and Legend Series Master Spas

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.