Search results for: 'e z lifter cape'

Support arm for CoverMate I and upper support arm for the CoverMate II and CoverMate Easy.

Over time, your spa or hot tub’s air controls may wear out, leaving you with less jetting action and much less enjoyment and relaxation. With the 1 Inch Molded Air Control (Grey), Master Spa Parts customers can affordably replace their air controls. This part is compatible with many models of Down East Spas, Freedom Spas, and the Master Spas® Legend Series.

Visionlift Pads provide a place for your Visionlift Boomerang cover lifter to rest – that’s not on the ground! They keep your cover lifter from getting scratched or torn up on the ground/deck.

This is the replacement right Large Bracket Cover for the CoverMate III cover lifter.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right large bracket cover is on the right side.*

This is the Right Support Arm for the CoverMate III Eco B cover lifter.

*To determine if this is the correct replacement support arm need, look at your cover in the open position. While facing the spa and open cover lifter, the right support arm is on the right side.*

This is a OEM factory direct replacement rubber stopper smash cap for the CoverMate I hot tub cover. Easily replace your old smash cap with this replacement!

This extender bracket set is used for and with the Leisure Concepts CoverMate III Eco B Cover Lifter

The Freemount UltraLift System **Cover Lifter Sold Separately**

1" Tablet Chemical Floater

Replacement screw kit for CoverMate Easy cover lifter. This kit includes all of the replacement screws for your cover lifter.

The Ultralift Undermount conversion kit allows for you to change your standard cover lift into one with an undermount. With this undermount, there is no more drilling into the side of your spa to install a cover lifter. This is bought in addition to a Ultralift cover lifter.

Boomerang brackets (1 pair) are specifically designed for use with the Visionlift Boomerang Cover Lifter by Ultralift. These brackets attach to your existing Ultralift sliding bracket, allowing your hot tub cover to fully open to the ground without the need for additional drilling.