Search results for: 'inch 90 pump undon'

The 1.5 inch standard pump union is a universal pump union used for complete assembly of your replacement pump. Should fit any 1.5 inch end on most pumps.

You need this to fully assemble your pump.

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

1" Sp x 3/4" Barb Adapter 90

The 1.5 inch Pump Split Nut is a replacement part for your pump union that needs to be re-plumbed.

Need to replacement your entire pump unit ? Don’t forget to buy all the parts you need to fully assemble the pump.

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.

The 2 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

2 inch Sweep Pump Union

The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.

Make sure to buy all the parts you need for complete assembly of your replacement pump.

O-Ring for Pump Wet End

Auxiliary Pump 1 Panel with 18 inch cable for VS Pack (V/N 52384)

The Pump Pad is your key to a quieter running spa/hot tub. Mount your pump on the pad to prevent transmission of the noise and vibration from the motor in your pump. Works well with pumps on most models.

The pump marvel drains up to thirteen times faster than siphoning or draining! Unlike a garden hose, this pump does not lose its prime, and can lift and discharge water up to 20’ high. Don’t be fooled, the pump marvel is not a siphon, it’s a true pump! Please note that this pump does not take electricity.