Search results for: 'spa heater x300035'

4.0 kW Replacement heater for Gecko Packs

MS300 AVU Control Pack with 4kW 825 Heater. This is for a 1 pump set up. 

5.5 kW Heater with cord and 3rd Sensor

2 x 2 inches Heater Tailpiece with Gasket

MS 501ZU Control Pack with 4.0 kW Heater

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

This 4.0 kW heater that is easily installable so you can get back to enjoying your heated swim spa or hot tub in no time at all. 

**REMOVING THE PLUG N CLICK OR EYELET CABLE FROM THE HEATER WILL VOID THE MANUFACTURES WARRANTY**

The Spa Dragon is a patented monitoring system with thermal backup protection that prevents freeze damage caused by equipment failure. Stay worry-free in winter, with real-time alerts and automatic heating activation—no matter where you are.

The 12-inch A&B M7 Temp/High Sensor is a replacement sensor for several Spa models including the Clarity, Down East, Contractor, Freedom, Getaway, H2X Swim Spas, Healthy Living Hot Spas, Legacy Whirlpool, Legend Series Master Spas, Michael Phelps Swim Spas and Twilight Series Spas. If you don’t see your model listed, it may still work – so please give our customer service a call!

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

MS1500 System (V/N 54493)