Search results for: 'thi covers with bar copper'

This left cover piece for the CoverMate III cover lifter snaps into the fitted location on the left side and covers all the pieces found there.

*To determine if this is the correct replacement cover pieceyou need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left cover piece is on the left side.*

The powder coated aluminum coupler for the CoverMate I, CoverMate II and CoverMate III is a direct replacement for the original bar.

The pivot arm is a direct replacement for the original bar on the CoverMate I and CoverMate I Eco B.

The right cover piece snaps into the fitted location on the right side and covers all the pieces on that side.

*To determine if this is the correct replacement cover piece you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the right cover piece is on the right side.*

If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.

Hot tub cover removal and storage can be difficult, so why not make it easier with a spa CoverShelf by Leisure Concepts. When removing your cover, simply fold it in half and slide it into the shelf, made of sturdy aluminum bars. There, it can rest securely off the ground and without obstructing your view!

The support arm lower for the CoverMate II is the direct replacement of the lower support arm in the bar that rest on the base of the hot tub.

Cover Valet Cover Caddy Extension

BWG Heater Plug N Click Adapter

This adapter eliminates the copper straps going from the heater to the circuit board. 

**This needs to be used on all heaters that come with the plug that is already attached. Removing the plug on the heater will void the warranty.**

PREMIUM UNDERMOUNT HOT TUB COVER LIFTER
-Works with all cover shapes
-Undermount design- no screwing into spa
-Gas spring assisted

**Swim spa kit available for units up to 54" tall

This is the replacement Bracket Kit for CoverMate II and it can be screw-mounted low on the spa. The Bracket Kit for the CoverMate II is for a model that needs only 18 inches of clearance behind the spa in order to operate. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate II Cover Lift. This part is sold for $73.45 here at Master Spa Parts.

This is the Locking Shock for the Cover Valet.

This locking shocks for your Cover Valet are the OEM, replacement part for the original shocks on the cover valet equipment.