Search results for: 'filter for The Twilight series 240'

Copper Heater Straps. These are the longer style heater straps. These are the most common heater straps. These heater straps are used to connect power from the PC board and the heater.

This is the Pivot Arm for CoverMate II and you will first need to remove the bolt connecting it to the spa mount bracket in order to replace it. The CoverMate II needs 18 inches of clearance behind the spa in order to operate. This part will ship to you free if it is part of a total order that is over $99 from Master Spa Parts.

The Extended Pivot Arm for CoverMate I is one of the parts that makes up this model of a hydraulic cover lifter. This Extended Pivot Arm has SKU# 100591 and is a replacement part for the CoverMate I, which is sold here by Master Spa Parts. It is recommended that you do not use the CoverMate I during high winds as to protect the cover and the hydraulic cover lifter from possible damage.

The Locking Shock for CoverMate 3 a replacement part for the CoverMate 3 hydraulic-assisted cover lift. It is important to remember to unlock the shock before pulling the CoverMate down on to your home spa so that you do not cause damage to the unit. This hydraulic-assisted cover lift is a lower-cost option that still delivers a quality lifting performance of the cover.

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

The Shock Locking for CoverMate III Eco B is one of the parts that make up this economically efficient choice for a hydraulic cover lifter. The Shock Locking connects to the shock itself and is sold for $34.50 by Master Spa Parts. It is recommended that you do not use the CoverMate III Eco B during high winds as to protect the cover and the hydraulic cover lifter from possible damage.

The CoverMate II Understyle Cover Lifter is there for you when you need it and tucked away in the background while your hot tub is in use! It has two plates that slide easily underneath your hot tub. The cover lifter only requires 18 inches of clearance behind your spa.

This is the Locking Shock for the Cover Valet.

This locking shocks for your Cover Valet are the OEM, replacement part for the original shocks on the cover valet equipment.

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.

The O-Ring for Power WOW Drain Plug is the O-ring that goes with the drain plug for the Pentair Power WOW pump (SKU : X275230).This creates a tight seal for wet end drain.

The Small Waterfall Pillow is a replacement for the pillow that originally came with your Master Spa hot tub if you have a waterfall feature.

Copper Heater Straps are used for connection of the Heater Unit of your spa to the Board within the Spa pack.

Easily installed.