Search results for: 'dimension 1 spx'

The Black Legend Lounge Small Corner Pillow is made to go with the Master Spa Legend Series Hot Tubs (2003 to 2004).

This heater is a replacement part for the original heater in your Master Spas swim spa and hot tub models. Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

This is an original heater assembly made by Balboa Group - leaders in manufacturing spa parts.

Features:

The 1.5 inch standard pump union is a universal pump union used for complete assembly of your replacement pump. Should fit any 1.5 inch end on most pumps.

You need this to fully assemble your pump.

The 1.5 inch Pump Split Nut is a replacement part for your pump union that needs to be re-plumbed.

Need to replacement your entire pump unit ? Don’t forget to buy all the parts you need to fully assemble the pump.

The 78" x 66" Hot Tub Cover (Long-edge Fold) is an exact Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated.

Note: This particular cover folds along the longer 78" edge. If you need a cover with these same dimensions (66" x 78") but that folds along the short edge, try our 66 × 78 Inch Hot Tub Cover (Short-edge fold).

Use this SilkBalance solution to clean your spa once a week. This SilkBalance water conditioner softens your water while neutralizing odors, all in seconds of using the product. Additionally, it protects your spa components to which make your spa experience the best it can be. 38oz bottle lasts two months.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

Regular-sized snap cap to cover the screws on your hot tub or spa. Hide rusty screws and keep them out of sight. This unit is in a portabello (greyish) color.

This is the OEM factory replacement screw kit for your CoverMate CoverShelf.

Copper Heater Straps are used for connection of the Heater Unit of your spa to the Board within the Spa pack.

Easily installed.

The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.

Make sure to buy all the parts you need for complete assembly of your replacement pump.