Search results for: 'cod swim spa air control'

Enjoy remote control access to your spa entertainment system with the EL Series IR Receiver.

7/8 inch Propulsion Motor Bushing

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.

The Black Wrap Around Master Spas Pillow will nicely replace your original hot tub pillow for certain Down East Master Spa hot tubs (2003-2009).

Quickly and easily clean away dirt and debris from your pool and spa performance filters with the Power Pic Reach! The 100% aluminum nozzle with last you season to season and will save you money by preserving the life of your expensive filters!

The Master Spa’s Grey Pop-up Speaker is a replacement for the speakers on your Master Spa series. Enjoy masterful sound as if you the band was playing right near your tub.

This is the replacement headrest for the Legend Series Pillow Filter Lid, sold here by Master Spa Parts. This replacement headrest is 23 inches wide and works with a variety of models in the Legend Series of home spas. This headrest comes in light grey and includes two cup holders. This replacement part will ship for free throughout the continental U.S. when included in an order of $99 or more.

Control your spa entertainment system using this waterproof unit. UV and Salt resistant Wired Stereo Remote is designed and built to withstand the harsh conditions that come with spa use.

The 2 Inch Diverter Valve in Grey by Master Spas is a replacement for your home spa’s original diverter valve, the part of your spa that allows you to control jet water flow. This assembly kit comes with all of the pieces you need to install a new diverter valve in your spa.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).