Search results for: 'outer filter frame getaway spa eco out charge system'

Have your original Down East Spas single or dual-pump topside control decal seen better days? Master Spa Parts offers the high-quality, OEM Overlay for Down East 1 & 2 Pump for MP30. This waterproof laminate will restore the function and appearance of your Down East Spa model’s topside controller.

The pressure switch - MAS400 - is specifically designed to replace the original pressure switches in the Legend Series Master Spas 2000 CS models. Control the water pressure in your spa with the right part.

Over time, your spa or hot tub’s air controls may wear out, leaving you with less jetting action and much less enjoyment and relaxation. With the 1 Inch Molded Air Control (Grey), Master Spa Parts customers can affordably replace their air controls. This part is compatible with many models of Down East Spas, Freedom Spas, and the Master Spas® Legend Series.

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.

Master Spa Parts offers an OEM 4-button decal for Down East Spas’ legacy models (1999-2003). Since the Down East 4-Button Overlay product is manufactured by Down East Spas, you can expect spectacular results when replacing your original adhesive controller overlay. Plus, a vast majority of Master Spa Parts products ship out within 24 hours of receiving your order!

The Master Spa® Factory OEM 84" x 70" replacement hot tub cover is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

As the "command center" of your spa, the circuit board is tasked with making sure your blowers, lights, air filtration system, and high-limit sensors work correctly. Whether you're looking to replace your Down East Spas MS510/1500/1600 Ext. PCB (V/N 53681) or another unit, Master Spa Parts offers a vast selection of replacement circuit boards. These are all competitively priced and ready to ship.

The Circuit board replacement for Twilight Series™ Spas always ships typically within 24 hours to customers ordering this and other spa circuit boards through the Master Spa Parts online store.

Replacement 7w UV bulb for Wave Zone 

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

Replacement Control Panel for Michael Phelps Swim Spas

MP8 Control Panel

The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.