Search results for: 'master sp2 2010 replacement headrests'

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

With free shipping to the Continental United States, Master Spa Parts has EcoPur® Charge filters for the Legacy Whirlpool spas available at a wonderful price. These filters remove heavy metals, biofilm, and bacteria that are bad for bathers and spa mechanisms.

Let's get you sitting pretty — order the Legacy EcoPur® Charge White Filter Set by Pleatco® today from Master Spa Parts!

This filter set replaces 268609, X268701, X268702 and x268706

This 67" x 78" Hot Tub Cover (Short-edge Fold) hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures you energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation that tapers to 4-inches along the sides, and a full-length heat seal to prevent heat loss. Additionally, it is made of a high-quality marine-grade vinyl covering that is mildew treated and protects against UV rays. Additionally, it boasts upgraded rubber grip handles.

Note: This particular hot tub cover folds along the shorter 67" edge. 

.

Replacment overlay for the TP500S Control panel in Clarity Spas

The Shock Locking for CoverMate III Eco B is one of the parts that make up this economically efficient choice for a hydraulic cover lifter. The Shock Locking connects to the shock itself and is sold for $34.50 by Master Spa Parts. It is recommended that you do not use the CoverMate III Eco B during high winds as to protect the cover and the hydraulic cover lifter from possible damage.

Replacement Control Panel for MP Swim Spas

MP9 Control Panel

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**

The 100mA (0.1A) is a replacement fuse meant to go in your home spa’s PC board. This fuse supplies power to your spa and the rest of its features, so maintaining it is key to the enjoyment of your spa. The slow blow fuse allows more power to flow without overwhelming the circuit.

The support arm lower for the CoverMate II is the direct replacement of the lower support arm in the bar that rest on the base of the hot tub.

2 x 3/4 inch 4 Barb SxSp Manifold

The 66" x 78" Master Spas® factory direct OEM replacement hot tub cover (SKU: 66x78) is designed to fit your Master Spas hot tub. It comes standard with a 1.5lb foam density, long steam stopper cushions to help prevent any sort of heat loss. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Note: This particular cover folds along the short edge. If you need a cover with these same dimensions (66" x 78") but that folds along the long edge, try our 66 × 78 Inch Hot Tub Cover (Long-edge fold).