Search results for: 'hudson bar spx part lpi14xc'

The coupler is used to connect the lower and side portions of your CoverMate Easy product.

Master Spa Parts offers this Outer Filter for Getaway Spas Eco Pur Charge System. This replacement filter weights 1.2 pounds and is five inches in diameter. This part has a SKU number of x268550 and is also known as a Getaway Outer Filter PMA-R5.

The powder coated aluminum coupler for the CoverMate I, CoverMate II and CoverMate III is a direct replacement for the original bar.

Master Spa Parts offers an OEM 4-button decal for Down East Spas’ legacy models (1999-2003). Since the Down East 4-Button Overlay product is manufactured by Down East Spas, you can expect spectacular results when replacing your original adhesive controller overlay. Plus, a vast majority of Master Spa Parts products ship out within 24 hours of receiving your order!

Over time, your spa or hot tub’s air controls may wear out, leaving you with less jetting action and much less enjoyment and relaxation. With the 1 Inch Molded Air Control (Grey), Master Spa Parts customers can affordably replace their air controls. This part is compatible with many models of Down East Spas, Freedom Spas, and the Master Spas® Legend Series.

The Rubber Pump Mount is suitable for the elastic mounting of your replacement spa pump. These rubber mounts are simple and economical construction elements. They help to reduce the vibrations that are generated by your pump.

The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.

Make sure to buy all the parts you need for complete assembly of your replacement pump.

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

The 2 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.