Search results for: 'power master 3.25 covers pm 2'
- Related search terms
- Master Spa - CLSEPRSET3 - Clarity & Healthy Living EPR Filter Set - (2) X268548 - PMA-R3 and PMA-EPR - (1) X268532
- Master Spa - X232607 - 1" Lighted Halo Air Control
- Master Spas - Topside Panel, MP900, No Overlay, For MS40 - X310203, 50305
- Master Spa - X245375 - 2 inch DSG 6-Spoke Diverter
- Master Spas, Down East, Emerald Spas Suction Drain Cover, 4-7/8 inch 0.D. VGB Law Compliant Replaced 0bsolete Original
Replacing fuses in your spa’s PC board is often a simple, straightforward solution to various problems that might arise with your spa or its features. The 20 Amp Power Input Fuse is a small piece in your spa’s PC board that allows your spa’s pumps to operate. Replacing this fuse allows you to continue to enjoy your spa and its features.
-
The 8' x 15' (94" x 180") Master Spas® swim spa replacement cover is a Master Spa Factory OEM replacement (SKU: x454158). All swim spa covers are made specifically to fit your Master Spas swim spa and come 6" thick in the middle and taper off to 4". This cover includes an energy efficient 1.5 lb foam density and a 24 R-value, with a full length heat seal and upgraded rubber grip handles (included!). They are also available in 18 different colors!
-
The 14.5' x 8' (94" x 174'') Master Spas® swim spa replacement cover is a Master Spa Factory OEM replacement part. All swim spa covers are made specifically to fit your Master Spas swim spa and come 6" thick in the middle and taper off to 4". This swim spa cover includes an energy efficient 1.5 lb foam density and a 24 R-value, with a full length heat seal and upgraded rubber grip handles (included!). They are also available in 18 colors to match the aesthetic of your hot tub area!
-
The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.
-
The Master Spa® Factory OEM 6.5' x 6.5' replacement hot tub cover (SKU: X454065)is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full length heat seal cushions that help prevent heat loss, and two upgraded black rubber handles.
-
Power Storm Jet Body No Longer Available This Body is recommended as a replacement X284843
-
The Master Spas® hot tub replacement cover 70" x 84" is an exact Master Spa Factory OEM replacement (SKU: X457084). It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and protects against UV rays.
Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.
-
This left cover piece for the CoverMate III cover lifter snaps into the fitted location on the left side and covers all the pieces found there.
*To determine if this is the correct replacement cover pieceyou need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left cover piece is on the left side.*
