Search results for: 'spx parts sanitizer'

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

The 1.5 inch Pump Split Nut is a replacement part for your pump union that needs to be re-plumbed.

Need to replacement your entire pump unit ? Don’t forget to buy all the parts you need to fully assemble the pump.

Designed specifically for preventing fasteners from coming loose after they are tightened, the ⅜’’ SS Split Lock Washer from Master Spa Parts is the perfect choice for fastening essential components of your spa.

Protect your speaker from excessive vibrations using the 80W Speaker Spider. The 100W Speaker Spider centers moving parts of the speaker allowing vibrations in an in and out motion instead of moving from side to side which can destroy your speakers.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The 8.8 Amp 2 speed 56 Frame Pump from Master Spa Parts is designed for flexibility and performance.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.

The 4.0kW Heater (V/N 50143) is a replacement part for selected models of the Down East Spas and Legend Series Master Spas

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The 4.0kW Heater (V/N 55950) is a replacement part for selected models of the H2X Swim Spas (Momentum 80, H2X Momentum) and Michael Phelps Swim Spas (Momentum 80)

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The pressure switch - MAS400 - is specifically designed to replace the original pressure switches in the Legend Series Master Spas 2000 CS models. Control the water pressure in your spa with the right part.