Search results for: 'swim4 sp1 12 parts'

The 2 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.

The Black Legend Lounge Small Corner Pillow is made to go with the Master Spa Legend Series Hot Tubs (2003 to 2004).

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

The 1.5 inch Pump Split Nut is a replacement part for your pump union that needs to be re-plumbed.

Need to replacement your entire pump unit ? Don’t forget to buy all the parts you need to fully assemble the pump.

Designed specifically for preventing fasteners from coming loose after they are tightened, the ⅜’’ SS Split Lock Washer from Master Spa Parts is the perfect choice for fastening essential components of your spa.

Protect your speaker from excessive vibrations using the 80W Speaker Spider. The 100W Speaker Spider centers moving parts of the speaker allowing vibrations in an in and out motion instead of moving from side to side which can destroy your speakers.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The 8.8 Amp 2 speed 56 Frame Pump from Master Spa Parts is designed for flexibility and performance.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.