Search results for: 'motor spa down east replacement filter'

This support arm lower for CoverMate Easy by Leisure Concepts is a direct OEM replacement for your original hot tub cover support arm.

Replacement screw kit for CoverMate III DeckMount brackets

Master Spa Parts offers the perfect replacement part for the main air valve knob on your Master Spas® H2X swim spas. The Master Air Control Handle, Width 3.25 Inch is compatible with 2008 and 2009 models of the H2X Cross Trainer, H2X Swim Spa, H2X Cross Trainer SJ, and H2X Cross Trainer 2.

Keep all your essential spa controls within reach with the topside controller for 2017 Twilight Series™ models from Master Spas®. This unit features touch control operation for ease of use. This touch panel only comes with the unit itself, not the protective overlay sticker.

This topside controller comes with free shipping to the continent United States, courtesy of Master Spa Parts!

This is the replacement for X310209, X310213 S/N: 50610 and X310308.

Measure the chemical balance of your hot tub water with AquaChek Spa 6-in-1 Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Chlorine, Total Bromine, Free Chlorine, Total Alkalinity, pH and Total Hardness.

The replacement, factory direct left outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left outer handle is on the left side.*

Swim Spa Combo-MSWIM15 Overlay 2010

The 100mA (0.1A) is a replacement fuse meant to go in your home spa’s PC board. This fuse supplies power to your spa and the rest of its features, so maintaining it is key to the enjoyment of your spa. The slow blow fuse allows more power to flow without overwhelming the circuit.

The 30 Amp Power Input Fuse by Master Spas is a replacement power fuse made to go in your spa’s PC board. This particular fuse supplies all of the power to your spa’s pumps. Keeping this fuse in tip-top shape is one of the best ways to ensure your spa’s functionality.

This wind strap for your hot tub cover helps to keep your Master Spas hot tub cover in tact during those blustery days! This 16’ long tie down strap is 2” wide and comes with plastic buckles.

The 78" x 66" Hot Tub Cover (Long-edge Fold) is an exact Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated.

Note: This particular cover folds along the longer 78" edge. If you need a cover with these same dimensions (66" x 78") but that folds along the short edge, try our 66 × 78 Inch Hot Tub Cover (Short-edge fold).

The Waterfall Diverter Valve, 1/2" 3-WAY GREY by Master Spas is a replacement part for your home spa’s original waterfall diverter valve. The water diverter valves in your spa allow you to control when and where water flows. The Waterfall Diverter Valve, 1/2" 3-WAY GREY is durable, affordable and easy to install at home.