Search results for: 'Outer filter for getaway spas eco our charge system'

This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**

The Ultralift Visionlift Boomerang cover lifter (SKU: 6132034) gives you the freedom to open your cover all the way to the ground. With this cover lifter and sliding bracket, you will not have to drill a second location on your spa cabinet for your lifter.

The 66" x 78" Master Spas® factory direct OEM replacement hot tub cover (SKU: 66x78) is designed to fit your Master Spas hot tub. It comes standard with a 1.5lb foam density, long steam stopper cushions to help prevent any sort of heat loss. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Note: This particular cover folds along the short edge. If you need a cover with these same dimensions (66" x 78") but that folds along the long edge, try our 66 × 78 Inch Hot Tub Cover (Long-edge fold).

Measure the chemical balance of your chlorine based water with AquaChek TruTest Chlorine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity

Measure the chemical balance of your bromine based water with AquaChek TruTest Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity

2" White Diverter Cap Replacement

This is the H2X Shaft Pin with SKU number X400130 and is one element that goes with the Blade Prop Kit. The H2X Shaft pin is a prop shaft pin and is a component of the wave propulsion.

The Down East Lounge Pillow perfectly matches the original pillow that fits in your Down East hot tub from Master Spas.

This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*

The 78" x 66" Hot Tub Cover (Long-edge Fold) is an exact Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated.

Note: This particular cover folds along the longer 78" edge. If you need a cover with these same dimensions (66" x 78") but that folds along the short edge, try our 66 × 78 Inch Hot Tub Cover (Short-edge fold).

This is the replacement part for the Plastic Bracket Left for CoverMate III for your CoverMate III Cover Lift. Our stylish composite mounting brackets combined with aluminum full-frame construction provides a perfect hydraulic cover lift option with no heavy lifting needed. This part is retails for $47.20 and is sold here at Master Spa Parts.

*To determine if this is the correct replacement bracket you need, look at your cover in the open position. While facing the spa and open cover lifter, the left bracket is on the left side.*

This is the OEM factory replacement screw kit for your CoverMate CoverShelf.