Search results for: 'directional for changing out twilight control module'

This 67" x 78" Hot Tub Cover (Short-edge Fold) hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures you energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation that tapers to 4-inches along the sides, and a full-length heat seal to prevent heat loss. Additionally, it is made of a high-quality marine-grade vinyl covering that is mildew treated and protects against UV rays. Additionally, it boasts upgraded rubber grip handles.

Note: This particular hot tub cover folds along the shorter 67" edge. 

.

Washer for the regular sized Snap Caps. These are the beauty caps that cover the screws that hold your side panels on providing your spa with a professional beautiful finish.

Measure the chemical balance of your bromine based water with AquaChek TruTest Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity

Measure the chemical balance of your chlorine based water with AquaChek TruTest Chlorine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity

The Windsor STS TV Lift Stand is a replacement TV Lift for your Windsor Spa Model STS (standard television set). Enjoy your favorite TV programming in your tub from any angle.

Enjoy premium sound from the 360 Freedom Spa Speaker specially designed and built for your Freedom Spa.

The Shock Non-Locking for CoverMate III Eco B is one of the parts that make up this economically efficient choice for a hydraulic cover lifter. The Shock Locking connects to the shock itself. It is recommended that you do not use the CoverMate III Eco B during high winds as to protect the cover and the hydraulic cover lifter from possible damage.

The Master Spa® Factory OEM 84" x 66" replacement hot tub cover is designed to fit your Master Spas® hot tub. This replacement custom hot tub cover is extremely energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*

The Grey Terminal Block for H2X is designed specifically to work with your H2X Swim Spa. Feed through up to 750V through this Terminal Block.

2 foot Master Spas STS Spa Harness Extension. This unit allows customers to create an extension to the wiring harnesses that come with the theater systems on Master Spa series of hot tubs.

Copper Heater Straps are used for connection of the Heater Unit of your spa to the Board within the Spa pack.

Easily installed.