Search results for: 'weir spa filter from parts'
- Did you mean
- weir spa filter foam parts
- weir spa filter forc parts
- Related search terms
- spa dealers in brentwood
- Spa cleaning gloves
- Spa heater sensor
- Spa covers legacy
- Spa mate III parts
The 2 Inch Diverter Valve in Grey by Master Spas is a replacement for your home spa’s original diverter valve, the part of your spa that allows you to control jet water flow. This assembly kit comes with all of the pieces you need to install a new diverter valve in your spa.
-
50/60Hz 12V DC Power Supply provides a regulated power source (up to 12V) to small appliances and devices with universal short-circuit protection. Designed and built to withstand the harsh conditions associated with use in spa and hot tub applications.
-
The Air Control 1” Toggle makes it easy to open and close the air control valve on your spa or hot tub. This spa air control toggle is designed to work with Master Spas® manufactured on or after 2012, as well as Clarity Spas (2013), Contractor Series (2012), and Legacy Whirlpool (2012). Check out the Product Description for specific model numbers.
-
This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover
*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*
-
Our Master Spas® 83" x 70" hot tub cover (SKU: 458771) is a factory direct OEM replacement cover specifically designed to fit your Master Spas® hot tub. Consisting of 1.5lb foam density, long steam stopper cushions, six-inch foam insulation, four inch tapered sides, upgraded rubber grip handles and a 24-R value (the greater the R-value, the better the heat storage and heat retention), this cover prevents heat loss and is extremely energy efficient.
Note: This hot tub cover folds along the long edge.
-
Replacement screw kit for CoverMate III DeckMount brackets
-
The 1.5 inch standard pump union is a universal pump union used for complete assembly of your replacement pump. Should fit any 1.5 inch end on most pumps.
You need this to fully assemble your pump.
-
The Black Flat Pillow from Master Spa will match your original hot tub pillow.
-
The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.
