Search results for: 'shroud i replac eco filter in master sp2'

You can only get the same functionality and appearance out of your two-button topside pump control by Down East Spas by choosing a decal made by the original manufacturer. That is why we are proud to offer the Down East 2-Button Overlay product. This decal for your topside pump control offers the same appearance and functionality as your original Down East Spas overlay — but for a fraction at what you’d pay at your local spa or hot tub shop!

This is the replacement right Large Bracket Cover for the CoverMate III cover lifter.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right large bracket cover is on the right side.*

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

The 78" x 66" Hot Tub Cover (Long-edge Fold) is an exact Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated.

Note: This particular cover folds along the longer 78" edge. If you need a cover with these same dimensions (66" x 78") but that folds along the short edge, try our 66 × 78 Inch Hot Tub Cover (Short-edge fold).

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**

The support arm lower for the CoverMate II is the direct replacement of the lower support arm in the bar that rest on the base of the hot tub.

The 120V Lift Motor is a gear motor to lift and power TV lift systems that come with the 2001-2003 Master Spa entertainment systems. This is for older spa models so give us a call to make sure it is the right part for you.

This 67" x 78" Hot Tub Cover (Short-edge Fold) hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures you energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation that tapers to 4-inches along the sides, and a full-length heat seal to prevent heat loss. Additionally, it is made of a high-quality marine-grade vinyl covering that is mildew treated and protects against UV rays. Additionally, it boasts upgraded rubber grip handles.

Note: This particular hot tub cover folds along the shorter 67" edge. 

.

The bracket is used for CoverMate easy to install the pole directly to your hot tub.

Connect your audio system to the controller of your Master Spa hot tub using this stereo adapter. Order the stereo adapter you need for your Master Spa controller today.