Search results for: 'inch pure sp1 h10 parts'
- Did you mean
- inch pure spa h10 parts
- inch pure spx h10 parts
- Related search terms
- sp1 spa jets frame cover13
- sp1 spa jets forc cover13
- sp1 spa jets forc cover17
- sp1 spa jets frame cover17
- sp1 cover13 lift 1 leisure spa parts
This 4.0 kW heater that is easily installable so you can get back to enjoying your heated swim spa or hot tub in no time at all.
**REMOVING THE PLUG N CLICK OR EYELET CABLE FROM THE HEATER WILL VOID THE MANUFACTURES WARRANTY**
-
This 67" x 78" Hot Tub Cover (Short-edge Fold) hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures you energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation that tapers to 4-inches along the sides, and a full-length heat seal to prevent heat loss. Additionally, it is made of a high-quality marine-grade vinyl covering that is mildew treated and protects against UV rays. Additionally, it boasts upgraded rubber grip handles.
Note: This particular hot tub cover folds along the shorter 67" edge.
.
-
A circuit board that's failed can put an end to your evenings of relaxation. We can help you bring back the good times with this Down East Spas and Master Spas® Circuit Board MAS425 PC Board (V/N 52364). Plus, you’ll spend much less than you would typically from your local repair shop! To make the offer even more attractive, our MAS425 replacement circuit board comes with free shipping to most United States locations (excluding Alaska and Hawaii).
-
The pivot arm is a direct replacement for the original bar on the CoverMate I and CoverMate I Eco B.
-
Our Master Spas® 83" x 70" hot tub cover (SKU: 458771) is a factory direct OEM replacement cover specifically designed to fit your Master Spas® hot tub. Consisting of 1.5lb foam density, long steam stopper cushions, six-inch foam insulation, four inch tapered sides, upgraded rubber grip handles and a 24-R value (the greater the R-value, the better the heat storage and heat retention), this cover prevents heat loss and is extremely energy efficient.
Note: This hot tub cover folds along the long edge.
-
3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.
-
This 5.5 kW heater that is easily installable so you can get back to enjoying your heated swim spa or hot tub in no time at all.
**REMOVING THE PLUG N CLICK OR EYELET CABLE FROM THE HEATER WILL VOID THE MANUFACTURES WARRANTY**
-
This extender bracket set is used for and with the Leisure Concepts CoverMate III Eco B Cover Lifter
-
MS8000 Relay for FST. This unit reverses polarity of the power in your spa’s entertainment system to raise and lower the television.
