Search results for: 'precision 8 spa master spa filter sku 268705'

The 100mA (0.1A) is a replacement fuse meant to go in your home spa’s PC board. This fuse supplies power to your spa and the rest of its features, so maintaining it is key to the enjoyment of your spa. The slow blow fuse allows more power to flow without overwhelming the circuit.

Filter weir w/ Vent hole for TS 240

This is the Plastic Bracket Right for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part retails for $47.20 here at Master Spa Parts.

**To determine if this is the correct replacement bracket you need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.**

The Windsor STS TV Lift Stand is a replacement TV Lift for your Windsor Spa Model STS (standard television set). Enjoy your favorite TV programming in your tub from any angle.

MS 1700 System Control Pack for Master Spas

Most likely you're visiting our online store today because your spa's circuit board has failed. And, we'd like to say you've come to the right place! As one of the most trusted online spa parts vendors, Master Spa Parts offers this MS1000 External PCB (V/N 53290) from the original equipment manufacturer at a great value. To make this offer even better, we provide free shipping on this external circuit board replacement for MS1000 to all destinations in the Lower 48.

This is the replacement Bracket Kit for CoverMate II and it can be screw-mounted low on the spa. The Bracket Kit for the CoverMate II is for a model that needs only 18 inches of clearance behind the spa in order to operate. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate II Cover Lift. This part is sold for $73.45 here at Master Spa Parts.

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

This is the replacement right aluminum bracket or your CoverMate Cover Lifter by Leisure Concepts.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.*

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

H2X MP30 Swim Overlay

The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.

Make sure to buy all the parts you need for complete assembly of your replacement pump.