Search results for: 'swim spa 12' parts'

Replacement support arm for the CoverMate I Eco B and the inner support arm for the CoverMate Freestyle.

Clamp, Hose 9/16 inch -1 1/16 inch SST

The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.

The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.

The Neck Jet Pillow from Master Spa fits in place of the hot tub pillow that came with your hot tub.

3/4" Eclipse DSG/Titanium Waterfall diverter

The pivot arm is a direct replacement for the original bar on the CoverMate I and CoverMate I Eco B.

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.

The Master Spa® Factory OEM 84" x 66" replacement hot tub cover is designed to fit your Master Spas® hot tub. This replacement custom hot tub cover is extremely energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

The right outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your cover in the open position. While facing the open cover, the right handle is on right side.*

The bracket is used for CoverMate easy to install the pole directly to your hot tub.

The coupler is used to connect the lower and side portions of your CoverMate Easy product.