Search results for: 'Antimicrobial blue (fine Thread) – Spas – Filters SKU: AKU0136''

50/60Hz 12V DC Power Supply provides a regulated power source (up to 12V) to small appliances and devices with universal short-circuit protection. Designed and built to withstand the harsh conditions associated with use in spa and hot tub applications.

This pivot arm assembly is made for your CoverMate Freestyle cover lifter.

This is the replacement Bracket Kit for CoverMate II and it can be screw-mounted low on the spa. The Bracket Kit for the CoverMate II is for a model that needs only 18 inches of clearance behind the spa in order to operate. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate II Cover Lift. This part is sold for $73.45 here at Master Spa Parts.

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

This is the Plastic Bracket Right for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part retails for $47.20 here at Master Spa Parts.

**To determine if this is the correct replacement bracket you need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.**

The Wrap Around Pillow from Master Spa is a larger pillow that wraps around the corner of your hot tub.

This is a factory replacement plastic bracket for your CoverMate CoverShelf.

The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.

Enjoying remote access to your favorite television shows is easy with this simple plug and play remote eye for your flat screen TV is perfectly suited for TV systems mounted with the Master Spa Hot Tub Series.

This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*

The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.

Make sure to buy all the parts you need for complete assembly of your replacement pump.