Search results for: 'Mounts spa lifter'

The pivot arm is a direct replacement for the original bar on the CoverMate I and CoverMate I Eco B.

PREMIUM UNDERMOUNT HOT TUB COVER LIFTER
-Works with all cover shapes
-Undermount design- no screwing into spa
-Gas spring assisted

**Swim spa kit available for units up to 54" tall

This is the replacement right Large Bracket Cover for the CoverMate III cover lifter.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right large bracket cover is on the right side.*

This Understyle Screw Kit for CoverMate II by Leisure Concepts is an OEM factory replacement screw kit.

This is the Right Support Arm for the CoverMate III Eco B cover lifter.

*To determine if this is the correct replacement support arm need, look at your cover in the open position. While facing the spa and open cover lifter, the right support arm is on the right side.*

The Bracket Kit for Master Spas CoverMate I with Master Bracket is one of the sections that makes up the CoverMate I model of a hydraulic cover lifter. This Extended Pivot Arm has SKU# 100571 and is a replacement part for the CoverMate I, which is sold here by Master Spa Parts. The Master bracket attaches to the wood in the upper-right corner to provide additional support.

The Left Support Arm for CoverMate III Eco B is one of the parts that makes up this economically efficient choice for a hydraulic cover lifter. The Left Support Arm connects to the support arm and is sold here by Master Spa Parts. Prevent possible damage to the lift by remembering to unlock the shock before pulling the CoverMate Cover down.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left support arm is on left side.*

The Ultralift Undermount conversion kit allows for you to change your standard cover lift into one with an undermount. With this undermount, there is no more drilling into the side of your spa to install a cover lifter. This is bought in addition to a Ultralift cover lifter.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The Pump Pad is your key to a quieter running spa/hot tub. Mount your pump on the pad to prevent transmission of the noise and vibration from the motor in your pump. Works well with pumps on most models.

The CoverCatch helps keep your spa cover close by and off the ground! It is ideal for smaller sizes spas and covers.

This is the Pivot Arm for CoverMate II and you will first need to remove the bolt connecting it to the spa mount bracket in order to replace it. The CoverMate II needs 18 inches of clearance behind the spa in order to operate. This part will ship to you free if it is part of a total order that is over $99 from Master Spa Parts.