Search results for: 'cover cod spa lifter'

This extender bracket set is used for and with the Leisure Concepts CoverMate III Eco B Cover Lifter

This 7.5' x 13' Swim Spa Cover for your H2X Therapool swim spa is a folding cover for your swim spa! This cover is extremely easy to operate and it makes taking on and off your swim spa cover easier than ever.

The CoverMate II Understyle Cover Lifter is there for you when you need it and tucked away in the background while your hot tub is in use! It has two plates that slide easily underneath your hot tub. The cover lifter only requires 18 inches of clearance behind your spa.

The Left Support Arm for CoverMate III Eco B is one of the parts that makes up this economically efficient choice for a hydraulic cover lifter. The Left Support Arm connects to the support arm and is sold here by Master Spa Parts. Prevent possible damage to the lift by remembering to unlock the shock before pulling the CoverMate Cover down.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left support arm is on left side.*

The Ultralift Undermount conversion kit allows for you to change your standard cover lift into one with an undermount. With this undermount, there is no more drilling into the side of your spa to install a cover lifter. This is bought in addition to a Ultralift cover lifter.

This is a OEM factory direct replacement rubber stopper smash cap for the CoverMate I hot tub cover. Easily replace your old smash cap with this replacement!

The Freemount UltraLift System **Cover Lifter Sold Separately**

If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.

Replacement screw kit for CoverMate II. This kit includes all of your replacement screws for your CoverMate II cover lifter.

The 8' x 15' (94" x 180") Master Spas® swim spa replacement cover is a Master Spa Factory OEM replacement (SKU: x454158). All swim spa covers are made specifically to fit your Master Spas swim spa and come 6" thick in the middle and taper off to 4".  This cover includes an energy efficient 1.5 lb foam density and a 24 R-value, with a full length heat seal and upgraded rubber grip handles (included!). They are also available in 18 different colors!

Replacement screw kit for the CoverMate I Master Bracket. This kit includes all of your replacement screws for your cover lifter bracket.

Visionlift Pads provide a place for your Visionlift Boomerang cover lifter to rest – that’s not on the ground! They keep your cover lifter from getting scratched or torn up on the ground/deck.