Search results for: 'master spx bearing assembly y940451'
- Related search terms
- Master Spa - X232603 - Air Control 1 inch Recoil Replacement Kit For Orbit LED SBK
- Master Spa - CLSEPRSET3 - Clarity & Healthy Living EPR Filter Set - (2) X268548 - PMA-R3 and PMA-EPR - (1) X268532
- Master Spas - X268532 - PMA-EPR, Eco Pur Charge Master Core Technology Mineral Filter - X268532
- Master spa filters for hot tub
- Master Spas Control Panel Twilight Series 6 Button (Football Panel) Overlay X509043
The 2 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.
Get all the parts you need to fully assembly your replacement spa pump.
-
The Upper Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.
-
The 2 Inch Diverter Valve in Grey by Master Spas is a replacement for your home spa’s original diverter valve, the part of your spa that allows you to control jet water flow. This assembly kit comes with all of the pieces you need to install a new diverter valve in your spa.
-
The replacement Lower Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.
-
This heater is a replacement part for the original heater in your Master Spas swim spa and hot tub models. Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.
This is an original heater assembly made by Balboa Group - leaders in manufacturing spa parts.
Features:
-
The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.
Make sure to buy all the parts you need for complete assembly of your replacement pump.
-
1 inch Spx3/4 inch 90 Degree Ell Barb Adapter
-
Thumbscrew 1/4 - 20 x 1.75 inch. These are used to secure your corner skirting pieces on your spa in place. This part is the longer of the two thumb-screws available.
-
The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.
-
The 1.5 inch standard pump union is a universal pump union used for complete assembly of your replacement pump. Should fit any 1.5 inch end on most pumps.
You need this to fully assemble your pump.
