Search results for: 'nonslip resistant sp2 part'

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

The 4.0kW Heater (V/N 50143) is a replacement part for selected models of the Down East Spas and Legend Series Master Spas

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.

The 8' x 19' Axis Swim Spa Cover for H2X Trainer 19 + Michael Phelps Momentum Spas is a hassle-free cover for your swim spa! Made with high-tech rolling technology, this energy-efficient cover is effortless to operate, and it makes taking on and off your swim spa cover easier than ever. Available in dark gray Midnight.

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.

This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The 4.0kW Heater (V/N 55950) is a replacement part for selected models of the H2X Swim Spas (Momentum 80, H2X Momentum) and Michael Phelps Swim Spas (Momentum 80)

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The 1.5 inch Pump Split Nut is a replacement part for your pump union that needs to be re-plumbed.

Need to replacement your entire pump unit ? Don’t forget to buy all the parts you need to fully assemble the pump.

The pressure switch - MAS400 - is specifically designed to replace the original pressure switches in the Legend Series Master Spas 2000 CS models. Control the water pressure in your spa with the right part.

Boomerang brackets (1 pair) are specifically designed for use with the Visionlift Boomerang Cover Lifter by Ultralift. These brackets attach to your existing Ultralift sliding bracket, allowing your hot tub cover to fully open to the ground without the need for additional drilling. 

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.