Search results for: 'slip sts forc part'

The 2 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

The 4.0kW Heater (V/N 50143) is a replacement part for selected models of the Down East Spas and Legend Series Master Spas

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.

This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The 4.0kW Heater (V/N 55950) is a replacement part for selected models of the H2X Swim Spas (Momentum 80, H2X Momentum) and Michael Phelps Swim Spas (Momentum 80)

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The 1.5 inch Pump Split Nut is a replacement part for your pump union that needs to be re-plumbed.

Need to replacement your entire pump unit ? Don’t forget to buy all the parts you need to fully assemble the pump.

The CoverCatch helps keep your spa cover close by and off the ground! It is ideal for smaller sizes spas and covers.

The pressure switch - MAS400 - is specifically designed to replace the original pressure switches in the Legend Series Master Spas 2000 CS models. Control the water pressure in your spa with the right part.