Search results for: 'Swim spa steps to get in to spa'
- Related search terms
- SPA CLEANER DESINFECTANT
- Spa ozone check valve 7-2108-01
- spa controller ts
- spa fill hose filter
- Spa hydrolics lift cover
Once you have the SmartBar hot tub bar installed it’s impossible to go back to the old ways. Just picture always having your favorite drink, smartphone, or e-reader just a reach away. This spa-side bar installs easily and comes with everything you need to set up your soon-to-be favorite hot tub accessory.
39" L X 14" W
-
1 inch, Clear Rubber Grommet for Weir Waterfall
-
The 66" x 78" Master Spas® factory direct OEM replacement hot tub cover (SKU: 66x78) is designed to fit your Master Spas hot tub. It comes standard with a 1.5lb foam density, long steam stopper cushions to help prevent any sort of heat loss. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.
Note: This particular cover folds along the short edge. If you need a cover with these same dimensions (66" x 78") but that folds along the long edge, try our 66 × 78 Inch Hot Tub Cover (Long-edge fold).
-
Thumbscrew 1/4 - 20 x 1.75 inch. These are used to secure your corner skirting pieces on your spa in place. This part is the longer of the two thumb-screws available.
-
This wind strap for your hot tub cover helps to keep your Master Spas hot tub cover in tact during those blustery days! This 16’ long tie down strap is 2” wide and comes with plastic buckles.
-
The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.
-
The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.
Make sure to buy all the parts you need for complete assembly of your replacement pump.
-
Visionlift Pads provide a place for your Visionlift Boomerang cover lifter to rest – that’s not on the ground! They keep your cover lifter from getting scratched or torn up on the ground/deck.
