Search results for: 'white is thi drain on my swim spa'

Support arm for CoverMate I and upper support arm for the CoverMate II and CoverMate Easy.

Copper Heater Straps. These are the longer style heater straps. These are the most common heater straps. These heater straps are used to connect power from the PC board and the heater.

The pivot arm is a direct replacement for the original bar on the CoverMate I and CoverMate I Eco B.

The Twilight Flex Pillow replaces the 2015 Twilight Series Spa pillow by Master Spas.

BWG Heater Plug N Click Adapter

This adapter eliminates the copper straps going from the heater to the circuit board. 

**This needs to be used on all heaters that come with the plug that is already attached. Removing the plug on the heater will void the warranty.**

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

Replacement screw kit for CoverMate III DeckMount brackets

The coupler is used to connect the lower and side portions of your CoverMate Easy product.

The CoverMate II Understyle Cover Lifter is there for you when you need it and tucked away in the background while your hot tub is in use! It has two plates that slide easily underneath your hot tub. The cover lifter only requires 18 inches of clearance behind your spa.

This Deckmount "L" Bracket is used to mount the CoverMate III cover lifter to your deck.

MS300 AVU Control Pack with 4kW 825 Heater. This is for a 1 pump set up. 

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.