Search results for: 'mounts spx lifter'

The Ultralift Undermount conversion kit allows for you to change your standard cover lift into one with an undermount. With this undermount, there is no more drilling into the side of your spa to install a cover lifter. This is bought in addition to a Ultralift cover lifter.

These 52” pivot arms allow for your Ultralift Undermount to be used with a selection of swim spas. This accessory is a great option if you own a swim spa and want to use the Undermount as your cover lifter.

The Left Support Arm for CoverMate III Eco B is one of the parts that makes up this economically efficient choice for a hydraulic cover lifter. The Left Support Arm connects to the support arm and is sold here by Master Spa Parts. Prevent possible damage to the lift by remembering to unlock the shock before pulling the CoverMate Cover down.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left support arm is on left side.*

The Bracket Kit for Master Spas CoverMate I with Master Bracket is one of the sections that makes up the CoverMate I model of a hydraulic cover lifter. This Extended Pivot Arm has SKU# 100571 and is a replacement part for the CoverMate I, which is sold here by Master Spa Parts. The Master bracket attaches to the wood in the upper-right corner to provide additional support.

This pivot arm assembly is made for your CoverMate Freestyle cover lifter.

2 inch Sweep Pump Union

This is the Pivot Arm for CoverMate II and you will first need to remove the bolt connecting it to the spa mount bracket in order to replace it. The CoverMate II needs 18 inches of clearance behind the spa in order to operate. This part will ship to you free if it is part of a total order that is over $99 from Master Spa Parts.

7/8 inch Propulsion Motor Bushing

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The CoverCatch helps keep your spa cover close by and off the ground! It is ideal for smaller sizes spas and covers.

Replacement screw kit for CoverMate II. This kit includes all of your replacement screws for your CoverMate II cover lifter.

This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*