Search results for: 'sp2 parts lock veri'

The 8' x 19' replacement cover (94" x 231") is designed to fit your Master Spas® H2X swim spas and Michael Phelps swim spas. This replacement spa cover (SKU: Cover 19) is a 4-piece cover that comes in 18 different color options. Both styles offer heat seam pillows that prevent heat loss through the seams of your spa and upgraded rubber grip handles.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.

Visionlift Pads provide a place for your Visionlift Boomerang cover lifter to rest – that’s not on the ground! They keep your cover lifter from getting scratched or torn up on the ground/deck.

SpaEase Classic Espresso SteP

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

The 1.5 inch Pump Split Nut is a replacement part for your pump union that needs to be re-plumbed.

Need to replacement your entire pump unit ? Don’t forget to buy all the parts you need to fully assemble the pump.

Protect your speaker from excessive vibrations using the 80W Speaker Spider. The 100W Speaker Spider centers moving parts of the speaker allowing vibrations in an in and out motion instead of moving from side to side which can destroy your speakers.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The 8.8 Amp 2 speed 56 Frame Pump from Master Spa Parts is designed for flexibility and performance.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.