Search results for: 'spa cover 8 x 11'

This Master Spa Factory OEM 66" x 84" hot tub cover replacement (SKU: X456684) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.

The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.

The Master Spa® Factory OEM 78" x 78" (6.5') replacement hot tub cover (SKU: X457878) is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

.

Spa Cover Strap Loick Set

Cover Valet Cover Caddy Extension

This is a replacement 8" 304 Stainless Handrail from Master Spas. 

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.

Swim Spa Filter Housing Weir Cover

PREMIUM UNDERMOUNT HOT TUB COVER LIFTER
-Works with all cover shapes
-Undermount design- no screwing into spa
-Gas spring assisted

**Swim spa kit available for units up to 54" tall

Stainless steel 3/8" Hex Nut is designed to be used on the fastening components of your spa propulsion system. Stay safe and keep your spa components from coming apart.