Search results for: 'spa cover 90 x 90'

This 67" x 78" Hot Tub Cover (Short-edge Fold) hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures you energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation that tapers to 4-inches along the sides, and a full-length heat seal to prevent heat loss. Additionally, it is made of a high-quality marine-grade vinyl covering that is mildew treated and protects against UV rays. Additionally, it boasts upgraded rubber grip handles.

Note: This particular hot tub cover folds along the shorter 67" edge. 

.

Filter Cover Black

Cover Valet Cover Caddy Extension

Spa Cover Strap Loick Set

The Bussman Fuse Holder (Series CHM) is a fuse holder for your Swim Spa Junction Box. Multiple fuse folders can be grouped together and used for even bigger boxes.

Swim Spa Filter Housing Weir Cover

PREMIUM UNDERMOUNT HOT TUB COVER LIFTER
-Works with all cover shapes
-Undermount design- no screwing into spa
-Gas spring assisted

**Swim spa kit available for units up to 54" tall

SpaBoss X-It makes it easy to switch sanitizers or to lower excessively high levels of chlorine or bromine in your spa or hot tub without having to drain and refill the whole thing.

The Master Spa® Factory OEM 78" x 78" (6.5') replacement hot tub cover (SKU: X457878) is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

.

This left cover piece for the CoverMate III cover lifter snaps into the fitted location on the left side and covers all the pieces found there.

*To determine if this is the correct replacement cover pieceyou need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left cover piece is on the left side.*

If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.