Search results for: 'temp sp2 heater assembly'

XP & XP Pro Shaft Nut Assembly

MS 501ZU Control Pack with 4.0 kW Heater

3/8" air bleed assembly black

The Sensor, 24” x ¼” F/560 M7 is a high limit temp replacement sensor for the MAS560 sensor found in most Down East and Legend Series Master Spas.

Don’t let a broken sensor prevent you from your enjoying your spa when you want to.

This 4.0 kW heater that is easily installable so you can get back to enjoying your heated swim spa or hot tub in no time at all. 

**REMOVING THE PLUG N CLICK OR EYELET CABLE FROM THE HEATER WILL VOID THE MANUFACTURES WARRANTY**

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The Upper Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.

The replacement Lower Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.

CYCLONE JET BODY ASSY SS 5"

The 2 Inch Diverter Valve in Grey by Master Spas is a replacement for your home spa’s original diverter valve, the part of your spa that allows you to control jet water flow. This assembly kit comes with all of the pieces you need to install a new diverter valve in your spa.

The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.

Make sure to buy all the parts you need for complete assembly of your replacement pump.

The 1.5 inch standard pump union is a universal pump union used for complete assembly of your replacement pump. Should fit any 1.5 inch end on most pumps.

You need this to fully assemble your pump.