Search results for: 'starter to ge inch thi spa'

Copper Heater Straps. These are the longer style heater straps. These are the most common heater straps. These heater straps are used to connect power from the PC board and the heater.

The pivot arm is a direct replacement for the original bar on the CoverMate I and CoverMate I Eco B.

The 6 horsepower, 1 speed, 56 Frame Sta-Rite / Pentair Pump is a replacement spa motor. Order your motor replacement today and get back to enjoying your spa!

BWG Heater Plug N Click Adapter

This adapter eliminates the copper straps going from the heater to the circuit board. 

**This needs to be used on all heaters that come with the plug that is already attached. Removing the plug on the heater will void the warranty.**

Replacement screw kit for CoverMate III DeckMount brackets

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

The coupler is used to connect the lower and side portions of your CoverMate Easy product.

This Deckmount "L" Bracket is used to mount the CoverMate III cover lifter to your deck.

MS300 AVU Control Pack with 4kW 825 Heater. This is for a 1 pump set up. 

The replacement Lower Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.

The 4.0kW Heater (V/N 55950) is a replacement part for selected models of the H2X Swim Spas (Momentum 80, H2X Momentum) and Michael Phelps Swim Spas (Momentum 80)

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.