Search results for: 'washer from spas cap'

3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.

MS8000 Relay for FST. This unit reverses polarity of the power in your spa’s entertainment system to raise and lower the television.

Contractor Series Filter PWW35L 2012, except CS 415.

Measure the chemical balance of your chlorine based water with AquaChek TruTest Chlorine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity

Measure the chemical balance of your bromine based water with AquaChek TruTest Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity

Measure the chemical balance of bromine based water with AquaChek Red 4-in-1 Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity and Total Hardness

Replacement screw kit for CoverMate II. This kit includes all of your replacement screws for your CoverMate II cover lifter.

SpaBoss Descummer boosts the effectiveness of the filtration system in your spa or hot tub, helping to keep the water clean and free of left-over contaminants.

This is the Locking Shock for the Cover Valet.

This locking shocks for your Cover Valet are the OEM, replacement part for the original shocks on the cover valet equipment.

Powerful radio reception with our standard FM antenna. This is a standard dipole indoor FM radio/stereo receiver that can be installed with your radio system to allow you to receive clear-sounding AM/FM broadcasts.

This screw kit is a bag of screws used for installation with the CoverMate I Eco B. They are factory direct, OEM replacement parts!

The Pillow Receptacle Stand is an OEM factory replacement part that is to be used only with the Genesys Adjustable Pillow (SKU: X540765)