Search results for: 'Air controlled on/off switch for spa jets'
- Related search terms
- spa boss metal out
- Spa indicator strips
- spa skiort screws
- spa H2X trainer15D
- spa cover for inground spa
Do you find yourself just laying your towels and robes on the floor, or on the steps of your hot tub? There’s a better way with the Towel Bar from Leisure Concepts. This towel bar is strong enough to hold even the heaviest robes. And, it can be installed in just a few minutes!
-
240V Transformer Balboa Instruments
-
If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.
-
1/4 inch Washer for Oversized Snap Cap. These are the beauty caps that cover the screws that hold your side panels on. Available in 2 different sizes and 3 different colors.
-
The SmartRail is a hand rail for recessed spas. With the SmartRail, Leisure Concepts solved the top pain points of those with recessed spas: finding a hand rail that is not only compatible with their setup, but one that is also easy to install. This product comes with free shipping to the Continental USA, compliments of Master Spa Parts.
-
This is the Pivot Arm for CoverMate II and you will first need to remove the bolt connecting it to the spa mount bracket in order to replace it. The CoverMate II needs 18 inches of clearance behind the spa in order to operate. This part will ship to you free if it is part of a total order that is over $99 from Master Spa Parts.
-
Boomerang brackets (1 pair) are specifically designed for use with the Visionlift Boomerang Cover Lifter by Ultralift. These brackets attach to your existing Ultralift sliding bracket, allowing your hot tub cover to fully open to the ground without the need for additional drilling.
-
The Master Spa® Factory OEM 84" x 66" replacement hot tub cover is designed to fit your Master Spas® hot tub. This replacement custom hot tub cover is extremely energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.
Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.
