Search results for: 'heater massage sp2 module 10'
- Did you mean
- heater massage spa module 10
- heater massage spx module 10
- Related search terms
- Massage Spa Jet Internal, 1-1/2" (Gray)23315-241-000
- Heater Gasket O-Ring for Master Spas X801765
- heater motor for master spa HL7
- heater motor for master spa HL7Laing 'E-14' pump
- heater for 2015 Master Spas Twilight series Hotub
The Master Spas® hot tub replacement cover 70" x 84" is an exact Master Spa Factory OEM replacement (SKU: X457084). It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and protects against UV rays.
Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.
-
The 70" x 83" Hot Tub Cover (Short-edge Fold) (SKU: 457187) is designed to fit your Master Spas® hot tub. This cover ensures extreme energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.
Note: This particular cover folds along the shortest 70-inch edge. For a hot tub cover folding on the long edge, please see 83" x 70" Hot Tub Cover (Long-edge Fold).
-
Our Master Spas® 83" x 70" hot tub cover (SKU: 458771) is a factory direct OEM replacement cover specifically designed to fit your Master Spas® hot tub. Consisting of 1.5lb foam density, long steam stopper cushions, six-inch foam insulation, four inch tapered sides, upgraded rubber grip handles and a 24-R value (the greater the R-value, the better the heat storage and heat retention), this cover prevents heat loss and is extremely energy efficient.
Note: This hot tub cover folds along the long edge.
-
This product is a pressure switch assembly specifically designed to go with select Down East and Legend Series Master Spas. If you don’t see your model listed, it may still work – so please give our customer service a call!
-
Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.
This mount should fit with most sensors.
-
The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.
-
The sensor assembly is specifically designed to go with Down East Spas and Legend Series Master Spas (select 1996-1999 models). It is a replacement for Balboa Dual Sensor Assembly with Temperature and Hi-Limit Sensor. Compatible with all Balboa systems that use this type of sensor.
